Get Started Core750
1. Setting Up Your Purifier
2. Purifier Components
3. Control Panel Display
4. Air Quality Indicator Ring
1. Setting Up Your Purifier
Please remove plastic bag on filter before operating purifier.
2. Purifier Components
Purifier Components
3. Control Panel Display
Control Panel Display
4. Air Quality Indicator Ring
Air Quality Indicator Ring
Replacing Your Filter
Replacing PCO Recharge Cell
Replacing UV LampReplacing Your FilterReplacing Your Filter
Filter Replacement Indicator
Yellow filter replacement light comes on to indicate filter has been used for 4 months, it may need to be replaced soon. In more extreme environments, it may require replacement immediately. The indicator light will turn red once filter needs to be placed after 6 months of use. Follow the instruction below to change filter and reset the filter timer. Check your filter after yellow indicator light comes on, if it looks dirty like the one in the video, we recommend replacing the filter immediately.
Follow these steps to change your filter
- Ensure power is off, then unplug machine from power source.
- Find the lock on the base of the unit.
- Unlock by sliding lock mechanism to the left.
- Lift up the top of the unit by the Top Rim.
- Remove old filter and place new filter into the same location as the original.
- Replace the top of the unit and slide the lock back to the right side.
- Press filter button for 5 seconds to reset the filter timer. The yellow or red light will flash then turn off to indicate filter timer has been reset successfully.
Replacing PCO Recharge CellReplacing Your PCO Recharge Cell
PCO Replacement Indicator
NOTE: This is an error indicator light only, it does not turn on or off the PCO function during normal operation. The indicator will remain off during normal use.
Top Cover Error Indicator
The PCO Replacement Indicator light will flash on and off when the Top Cover is open or not fully engaged. The flashing will stop once the Top Cover has been installed properly. Twist the Top Cover firmly in the clockwise direction until you hear an audible click sound.
PCO Replacement Indicator
The PCO Replacement Indicator light turns yellow when the Recharge CellTM is still working but has reduced operation and needs to be replaced immediately.
The PCO Replacement Indicator light turns red when your purifier unit has operated for enough hours that the Recharge CellTM must be replaced and has stopped working.
Once a new Recharge CellTM has been installed (see Replacing Recharge CellTM section below for instructions), the PCO Replacement Indicator error lights will turn off to indicate PCO function is operating normally again.
Replacing PCO Recharge Cell
NOTE: Disconnect power before doing any work to your Purifier.
- Turn Top Cover counterclockwise (A) and remove (B).
- Use your fingers or pliers to slide out old Recharge CellTM from Purifier unit and discard.
- Remove Red Cap from bottom of new Recharge CellTM (Model#R0002).
- Slide in new Recharge CellTM into Purifier unit by aligning keyholes.
- Align the Top Cover with Puraclenz® logo 30° counterclockwise to the front of the Purifier unit as highlighted in Diagram 5. Then place the Top Cover into Purifier as highlighted in Diagram 6 (A). Twist the Top Cover clockwise (B) until you hear an audible click from the safety latch (highlighted) to automatically resume operation.
WARNING: Skin or eye damage may result from directly viewing the light produced by the lamps in the Recharge CellTM apparatus. Always disconnect power before relamping or servicing. Replace Recharge CellTM with Puraclenz® Model R0002.
Replacing UV LampReplacing UV Lamp
UV Lamp Replacement Indicator
NOTE: This is an error indicator light only, it does not turn on or off the Germicidal UV Lamp function during normal operation. The indicator will remain off during normal use.
The UV Lamp indicator will turn red when the Germicidal UV Lamp has reached the end of its usable life either from detection of a damaged lamp or from reaching 20,000 operating hours counted. At this time, the UV Lamp should be replaced immediately.
Once a new Germicidal UV lamp has been installed (see Germicidal UV Lamp Replacement section for instructions), the red UV Lamp light on the button should turn off automatically to indicate successful lamp replacement. However, it is still necessary after replacing lamp, to long press the UV lamp indicator for 5 seconds to reset UV lamp timer.
Replacing the Germicidal UV Lamp
WARNING: Ultraviolet radiation is dangerous to eyes and skin, please do not use Germicidal UVC emitter outside the device. Please do not look into the UV lamp when it is ON.
- Ensure power is off, then unplug machine from power source.
- Find the lock on the base of the unit.
- Unlock by sliding lock mechanism to the left.
- Lift up the top of the unit by the Top Rim.
- Remove the filter.
- Remove the black UV housing.
- Remove the old UV lamp by pulling up on the base of the UV lamp. Recycle old UV lamp by following your local municipality guidelines.
- Take care to hold white portion only of new UV lamp. Do not touch its glass tube. Place the new UV lamp back into the socket by aligning its pins to match socket.
- Reinstall the black UV housing and the filter.
- Replace the top of the unit and slide the lock back to the right side.
- Successful UV lamp change will be indicated by the UV lamp light turning off.
WARNING: Skin or eye damage may result from directly viewing the light produced by the lamps in the Recharge CellTM apparatus. Always disconnect power before relamping or servicing. Replace Lamp with Puraclenz® Model#R0011.
Save the hassle by bundling up your subscriptions.
Let us take care of your purifier’s maintenance so you can breath easy. Just select the subscription for your desired replacement part below and we’ll automatically deliver all the parts you need, so you’ll never have to worry about maintenance again!
Subscribe and Save 10%
Bundle and Parts Subscriptions.
Free Shipping
In the Contiguous United States.
Automatic Delivery
Parts arrive when it’s time to replace.
No commitment
Change anytime.
Core™ 750
Replacement Parts
Core™ purifiers have indicator lights that automatically notify you when to change the Recharge Cell, Filter and Lamp. It’s fast and simple – no mechanical skills needed.
Core™ 750 Parts Subscription Bundle
+ FREE SHIPPING
Bundle includes all the parts you need to keep your Core™ 750 purifier operating at optimal performance.
Recharge Cell™
+ FREE SHIPPING
Replacement Cell for Core™ 750 Purifiers. The Recharge Cell will run for over 2 years before it needs to be replaced.
Auto-Ship Subscription
One-Time Purchase
Core™ 750 Filter
+ FREE SHIPPING
Replacement Filter for Core™ 750 Purifiers. The Filter needs to be changed every 6 months.
Auto-Ship Subscription
One-Time Purchase
Core™ 750 Lamp
+ FREE SHIPPING
Replacement Lamp for Core™ 750 purifiers. The Lamp runs for 2 years and is easy to replace in just minutes.
Auto-Ship Subscription
One-Time Purchase
Pre-Order Ships Around 12/01/2023
Puraclenz Core™ Technology
Explore knowledge about Puraclenz Core Technology and the most commonly asked product-specific questions.
Need More Support?
Contact us for more support on your Core 750. Use the Chat button on the bottom right of this page or click the link below to submit a request.
